Analog recording
Setting the track numbers automaticallyNote:
The level sync function uses the recording source
The level sync function is turned off during analoglevel to detect the end and beginning of tracks.
recording. Press the o REC button (or the remoteTherefore, in the cases given below, the track
controller RECo button) and assign the track numbersnumbers may not be properly assigned.
automatically.Y The recording on the cassette tape is poor (e.g.,
To have the track numbers assigned automatically by thethe space between songs contains much noise).
CDR-205X, turn on the level sync function.Y With music such as classical music where there
may be very low volumes.
Y Where the space between songs is extremely short.1During recording or while in the
(23,m-11)Y If the signal at the tuner is weak (excessive noise).recording standby state, press the
Y When recording from turntables.
EDIT/NO button repeatedly until "Level
Sync?" appears.To return to manual assignment of the track
numbers
EDIT/NO
Set "Off" at step 2 (see page 27).
2Press the YES button.
The current setting appears. The current setting
is given on the left side (for the display given
below, the current setting is "Off").
YES
Operations3Press the YES button.
The level sync function turns on. Press the EDIT/
NO button to return to the previous setting.
YES
25 |