Troubleshooting
If you have any problems with the unit, please check the troubleshooting table below first.
For any problems not covered in the table, please consult your nearest Onkyo authorized service center.
SymptomCauseRemedy
STANDBY/ON button is pressed,YPower cord plug is not properly YInsert the plug firmly.
but power does not come on.connected to AC outlet.
Disc is loaded in the disc tray,Y Disc is in the disc tray upside down. Y Load the disc with the label facing
but playback will not begin.upward.
Y Disc is dirty.Y Clean the disc.
Y Moisture has accumulated inside Y Remove the disc from the disc tray,
the CD player.place the CD player in a warm place
and leave the power on for about
one hour.
No soundY Incomplete or incorrect connec- Y Check all cable connections. (See
tions.pages 10-12)
Y Insert all plugs firmly into jacks.
Y Improper input selector switch set- Y Set switch to proper position. See
ting on amplifier.your amplifiers operating instruc-
tions for more information.
Disc skippingY Disc is dirty.Y Clean the disc. (See page 19)
Y Disc is scratched.Y Replace the disc.
Y CD player has been bumped.Y Place the CD player in a more stable
location.
Search time (when moving toY Disc is dirty.Y Clean the disc. (See page 19)
a specific track) is extremely
Y Disc is scratched.Y Replace the disc.
long.
Track numbers cannot beY No disc in the tray.Y Load a disc into the tray.
stored in the memory.Y A track number not on the disc is Y Use only the track numbers on the
being input.disc.
Noise during playY Interference from TVY Turn off the TV, or move the unit
farther from the TV.
Remote controller does notY Battery level is low.Y Replace the batteries.
function.
Y Your position is too far from the Y Remote controller is possible within
unitOs remote control sensor or outa distance of approximately 5
of the sensorOs detection angle.meters from the unitOs sensor and a
detection range of 30!.
Y An obstacle exists between you and Y Operate from a different position or
the unitOs remote control sensor.remove the obstacle.
Y The system components are not Y Connect the system components
connected properly.properly according to the A-905X
instruction manual.
20 |